FAQs

FAQs Shortcodes

You can show the faqs with Porto FAQs shortcodes.


Show Filter


The amp load at stall torque is 1.3A (4.8V)

The new one is visible at night time: Miuzei ght Vision Camera for Raspberry Pi

There are two options: 3.3 volts or 5 volts. It depends on how much cooling you need and where you connect the fan on the GPIO.

Yes there is a warranty, contact us directly to this mail:support@miuzeipro.com

The servo is 1 1/4″ from the top of the rotating horn to the base, 1 1/4″ across the two mounting tabs, 15/16″ across the body of the servo between the mounting tabs and 1/2″ thick. The leads are 10″ long.

No,it could fit with 3.5″ touch screen

No

2-3 inches

No, it will damage the battery pack.

About 10.4*7.4*3.7cm.

They have different power supply(2.5A vs 3A power supply)

It would not fit inside the 7″ touch screen but it could power the 7″ touch screen.

Yes they will, but only recommended for Foamies, like the type built by Flite Test

The battery pack provide UPS on power failure.

3 X 3 X 0.7cm thick

The case could not fit with the 3.5 inch LCD, as you need to remove the top three layers. And here is our new case for the 3.5 inch screen
http://www.amazon.com/dp/B07L4BXL1T

No, it is not an infrared camera

It is not fit on a 1/16 remo rocket.

The case not compatible with the POE hat.

I am sorry it would not work with POE hat.